7. Column Interaction Diagram - spColumn Software

spColumn is a StructurePoint software program that performs the analysis and design of reinforced concrete sections subjected to axial force combined with uniaxial or biaxial bending. Using the provisions of the Strength Design Method and Unified Design Provisions, slenderness considerations are used for moment magnification due to second order effect (P-Delta) for sway and non-sway frames.

For this column section, investigation mode is used, service loads are defined, and slenderness effects are considered using CSA A23.3-19 provisions. The model input parameters, results, and report (for load combination #7) are shown below.

Figure 7 - spColumn Interface

Figure 8 - spColumn Model Editor

Figure 9 - Defining Slenderness - Load Combination #7 (spColumn)

Figure 10 - Defining Columns Above / Below (spColumn)

Figure 11 - Defining Beams in X-Direction (spColumn)

Figure 12 - Defining Loads / Modes (spColumn)

Figure 13 - Defining Load Combination #7 (spColumn)

Figure 14 - Column Section Interaction Diagram about the X-Axis - Design Check for Load Combination #7 (spColumn)